Elite Screens Insta-DE 2 Guía de instalación descargar pdf (Pagina 3)

Rev012313-JA www.elitescreens.com 3

ATTENTION: Handle with care to avoid permanent damage to this product

3. Once the edge has been tapped, apply the spray adhesive to both the wall and on the back of the Insta-

DE2 material. We recommend applying the film in 1 foot increments for best results.

4. Wait until the spray adhesive is dry before attaching the material to the wall. Do not attach the material

to the wall if the spray adhesive is still wet. This is to avoid creating air pockets (bubbles) as the adhesive

will try to escape when the Insta-DE2 material is attached to the wet surface.

5. Once the spray adhesive has been dried (surface and material should feel sticky), begin to unroll and

attach the material to the wall.

6. Smoothen out the material with a smoothing tool (not included). Use an upward and downward motion

to remove any air bubbles and assure the material is attached.

7. Repeat the process throughout the rest of the material.

8. Use a soft damp cloth to clean and remove any residue.

Caution:

The spray adhesive is meant to be permanent for the life of the product.

Adhesive black velvet border installation

1. Measure the top/bottom and left/right sides of the Insta-DE2 screen to obtain the required length of the

velvet border you will need to use for bordering your screen.

1 2 3 4

Sin comentarios

Elite Screens Insta-DE 2 Guía de instalación Pagina 3